Setup — which sensors and actuators are fitted
Tick what is physically wired. The dashboard then shows a fitted-but-silent channel as no signal instead of hiding it, so a failed sensor is visible rather than absent. Saved in this browser only.
One channel per probe.
Analog. Must be on GPIO 4–10 (ADC1); ADC2 pins do not read while WiFi is on.
Each sensor reports two channels, temperature and humidity.
Sensors
Nothing configured or reporting yet.
- Open Setup above and tick what you have wired.
- Check the Device ID matches what the pod prints at boot.
- A
devicesrow must exist for that ID or telemetry is dropped silently.
Channel 4 — irrigation output
The pod switches the load off by itself when the timer expires, even if it loses connectivity. It never waits for an off command.
Activity
Pods
Add or edit a pod
The pod names itself from its MAC address at boot — it prints
device_id=… on the serial console. Give it a name you will recognise;
the ID is what the backend keys on.
Account
Signing out clears the saved token from this browser only — nothing changes on the backend.
Appearance
Coming soon
Trends (sensor history) and Alerts (staleness / no-telemetry notifications, spec S-A2) need new backend endpoints that don't exist yet — the tabs above are here so you can see where they'll land.